The Pentair ScreenLogic Interface for Macintosh Desktop Computers is NOT COMPATIBLE with the recently released 64bit speed Macintosh CATALINA Operating System. I there someway to see what the S2IPA network settings are without being connected to my network so I can see if DHCP is set and diagnose what is going on? Or what is a better idea, I really have tried everything I know? Going to try Pentair support tomorrow over lunch. The ScreenLogic2 Interface Wireless Connection Kit (P/N 522620) can be used to eliminate the need to run this wire where impossible or impractical to do so. I have the iPhone app and it doesn't connect to the S2IPA either which is no surprise. I am sure that if the S2IPA doesn't get a proper IP address on my network it won't communicate properly. I have powered off/on the whole PL4/S2IPA and my router several times and I have reset the S2IPA several times but still no worky.So it looks to me like the S2IPA is not getting an IP address (in the 10.x.x.x range that my router uses for my internal network), yet by default the S2IPA is supposedly set to DHCP. I check my Router Logs and I don't see the device S2IPA at all.I am typing in the correct correct system name, 'Pentair: XX-XX-XX', where XX-XX-XX represents the characters that are written on my S2IPA I didn't type XX-XX-XX.When I run the ScreenLogic Connect software on my PC I get an error 'System Not Found' I have a proper red light on the S2IPA so it is powered from the PL4 com port J20Ĥ.I have triple checked all wires and connections.My router assigns it a 10.x.x.x address through DHCP to the PC. I have previously tested this LAN connection with a PC (which is set to use DHCP just like the S2IPA supposedly defaults to use as well) and it connects to the network and internet just fine.

The S2IPA is connected directly to my router by wired (CAT6) LAN RJ-45 cable and lights show I have a 10/100 connection on the router Still some users get troubled about which device should they use as the adapter. I have hardwired it correctly(J20 Com Port - 4 wires) to the ScreenLogic2 Interface Protocol Adapter (S2IPA).ģ. ScreenLogic Protocol Adapter This is not a major point. I have an Pentair EasyTouch PL4 control panel.Ģ.

Pentair screenlogic protocol adapter